Thunderbolt

From airraidsirens.net, the Internet's premiere site for siren information and discussion
Jump to navigation Jump to search
Thunderbolt
[[File:|200px]]
Company Federal Signal Corporation
Produced 1952-1990
Type Electromechanical
Sound output 126
Succeeded by 2001SRN
An exploded view of the Thunderbolt siren as well as a parts list for the siren.

The Thunderbolt siren was a supercharged electromechanical siren produced by Federal Electric, which later became known as Federal Sign & Signal and Federal Signal. The Thunderbolt has seven chopper levels, or voltage settings, that allow the pitch to be adjusted on the chopper, the Thunderbolt can come in three port ratios, 5 Port, 4/5 Port, and 5/6 Port.

Thunderbolt 1000

The Thunderbolt 1000 is a single-tone siren. The 1000's chopper has 5 ports.

Thunderbolt 1000T

The Thunderbolt 1000T is a dual-toned siren. The 1000T can come in 4/5 or 5/6 port ratios, which correspond to minor 3rd and major 3rd intervals, respectively.

Thunderbolt 1003

The Thunderbolt 1003 uses two solenoids that are attached to the throat of the horn. Each solenoid has a gate that closes off one row of ports on the stator. They are used to create alternating steady, alternating wail, pulsed steady, and pulsed wail signals, which can be used as a fire warning. Otherwise, it is identical to the 1000T.

Other models

Thunderbolt 2000

The Thunderbolt 2000 is a single-tone and dual-tone variant from the 1950s with a gas-powered blower.

System 7000

The System 7000, a variant of the original Thunderbolt versions, is equipped with a self-contained generator. This particular series came in three versions; the 7012, corresponding to the 1000. the 7022, corresponding to the 1000T. and the 7026, corresponding to the 1003.

Other Information

Blowers

All Thunderbolts run on what is known as a "blower" to push air to the top of the siren to increase sound output. The type of blower has changed during production; starting in 1952, thunderbolts used a 6M, then switched to the 5M blower around 1960, later to the 4M in the late 1960s. This was used up until 1980, when thunderbolts started to have the 4M roots blower mounted vertically, which was used all the way up to the end of its production in 1990.

Horns

A note able feature of some thunderbolts is their horn. The earliest thunderbolts had metal crossbars, now referred to as "Jailbars", at the end/mid section of the horn that acted like reinforcements. Since the Thunderbolt was new at the time, Federal wanted to make sure the horn did not warp or bend as this would ruin the sound output. After 1955, it became obvious that the thick metal panels used for the horn were strong enough to not compromise the horn itself. Federal changed the design and instead put the mesh screens to help keep out any unwanted animals or debris.