2T22 and 3T22: Difference between revisions
(Created page) |
BrendanW0214 (talk | contribs) No edit summary |
||
(16 intermediate revisions by 11 users not shown) | |||
Line 1: | Line 1: | ||
{{Infobox siren | {{Infobox siren | ||
|title= 2T22 and 3T22 | |||
|image= [[File:3t22 official.jpg|thumbnail|3T22]] | |||
[[File:2T22.png|thumb|A 2T22. Note the lack of solenoid boxes.]] | |||
|company= [[Federal Signal Corporation]] | |company= [[Federal Signal Corporation]] | ||
|type =[[Electromechanical]] | |||
|output= 113 | |output= 113 | ||
|neigh= 7.5 - 10 | |||
|manual= http://www.civildefensemuseum.com/sirens/manuals/255A152H-2T22-3T22.pdf | |||
}} | }} | ||
== General == | |||
The 2/3T22 was an omnidirectional siren produced by [[Federal Signal Corporation]]. The design features a single motor in the middle with a twelve-port rotor/stator set on top and a 10-port set on bottom. Both rotors measured 14 inches in diameter, and are identical to rotors used on the model 3 and 2001. The 3T22 model featured solenoids attached to the top and bottom intakes to produce a third signal. The 2T22 lacked the additional signal option. | |||
Both models were available in single and three phase versions. Three phase models used either a GE (early) or Marathon 10 horsepower motor. The only motor used on the single phase model was the Northwestern Electric 7 1/2 horsepower repulsion-induction motor. | |||
[[Category:Federal Signal Corporation]][[Category:Omnidirectional Sirens]][[Category:Dual Toned Sirens]] | A fully assembled siren weighs close to 700 pounds, including the pole mount bracket. | ||
[[Category:Federal Signal Corporation]][[Category:Omnidirectional Sirens]][[Category:Dual Toned Sirens]][[Category:Sirens]][[Category:Electromechanical Sirens]] |
Latest revision as of 22:48, 8 November 2017
2T22 and 3T22 | |
Company | Federal Signal Corporation |
---|---|
Type | Electromechanical |
Sound output | 113 dBc at 100 feet |
Horsepower | 7.5 - 10 |
Documentation | Manual |
General
The 2/3T22 was an omnidirectional siren produced by Federal Signal Corporation. The design features a single motor in the middle with a twelve-port rotor/stator set on top and a 10-port set on bottom. Both rotors measured 14 inches in diameter, and are identical to rotors used on the model 3 and 2001. The 3T22 model featured solenoids attached to the top and bottom intakes to produce a third signal. The 2T22 lacked the additional signal option.
Both models were available in single and three phase versions. Three phase models used either a GE (early) or Marathon 10 horsepower motor. The only motor used on the single phase model was the Northwestern Electric 7 1/2 horsepower repulsion-induction motor.
A fully assembled siren weighs close to 700 pounds, including the pole mount bracket.